Alloy development can simplify low-cost gas metal arc weld (GMAW)-based 3-D printing by making it easier to print quality parts with minimal metallurgical or welding experience. Previous work found good properties in aluminum alloys, particularly in the aluminum-silicon 4943 (Al-5.5%Si-0.4%Mg) and 4047 (Al-11.6%Si) alloys. These alloys were easy to print, but could benefit from alloying to increase ductility and to minimize or redistribute porosity. The purpose of this study was to modify 4943 and 4047 alloys and rapidly screen their performance for use as feedstock for improved 3-D printability. The 4047 and 4943-based alloys were modified with additions of magnesium, strontium, titanium boride, and combinations thereof. Wedge-shaped castings were used to efficiently screen alloying additions over the same ranges of solidification rates as those observed in GMAW-based 3-D printing. The alloying additions were most effective at modifying the high-silicon 4047 alloy whereas no change in microstructure was observed in the low-silicon 4943 alloy. Strontium was an effective modifier of the high-silicon alloy. Titanium boride was not observed to have a grain refining effect on aluminum dendrites on its own, although the combination of strontium and titanium boride produced the most refined eutectic structure in the high-silicon alloy. Future work should evaluate the singular effects of strontium, titanium boride, and the combination of strontium and titanium boride additions in weld-based 3-D printing.
Pearce, J. (2019). Hypoeutectic Aluminum-Silicon Alloy Development for GMAW-Based 3-D Printing Using Wedge Castings. Afribary. Retrieved from https://tracking.afribary.com/works/hypoeutectic-aluminum-silicon-alloy-development-for-gmaw-based-3-d-printing-using-wedge-castings
Pearce, Joshua "Hypoeutectic Aluminum-Silicon Alloy Development for GMAW-Based 3-D Printing Using Wedge Castings" Afribary. Afribary, 15 Apr. 2019, https://tracking.afribary.com/works/hypoeutectic-aluminum-silicon-alloy-development-for-gmaw-based-3-d-printing-using-wedge-castings. Accessed 26 Nov. 2024.
Pearce, Joshua . "Hypoeutectic Aluminum-Silicon Alloy Development for GMAW-Based 3-D Printing Using Wedge Castings". Afribary, Afribary, 15 Apr. 2019. Web. 26 Nov. 2024. < https://tracking.afribary.com/works/hypoeutectic-aluminum-silicon-alloy-development-for-gmaw-based-3-d-printing-using-wedge-castings >.
Pearce, Joshua . "Hypoeutectic Aluminum-Silicon Alloy Development for GMAW-Based 3-D Printing Using Wedge Castings" Afribary (2019). Accessed November 26, 2024. https://tracking.afribary.com/works/hypoeutectic-aluminum-silicon-alloy-development-for-gmaw-based-3-d-printing-using-wedge-castings