ABSTRACT
This work is aimed at the removal of hazardous gases and dust particles, air channeling etc. This work is aimed at achieving industrial waste control therein safe – guarding the immediate environment.
Chapter one accounts for the introduction of the project. Chapter two involves literature review in the origin, types and alternative device is compared. Chapter three discussed the design analysis of the project. In chapter four, the sequence of operation and material selection for the construction of the project were discussed. In chapter five, the average cost of material, labor and other attached costs were analysed and the total sum was ascertained. In chapter six, the project was tested for functionality and its performance was satisfactory and then recommendations for alternations in future and applications and a final conclusion was the last section.
TABLE OF CONTENTS
Title Page
Approval Page
Dedication
Acknowledgement
Abstract
Table of Contents
Table of Illustrations
CHAPTER 1:INTRODUCTION
CHAPTER 2:LITERATURE REVIEW
2.1Origin of Fans
2.2Types of Fans
2.3Blowers
2.3.1 Definition and Capacity of Blowers
2.3.2 Operating Principles for Blowers
2.3.3 Applications of Blowers
2.3.4 Advantages of Blowers
2.3.5 Material Selection for Blowers
2.4Types of Blowers
CHAPTER 3:DESIGN OF INDUSTRIAL FAN
3.1Basics of Lift and Drag
3.1.1Conventions for Lift and Drag Forces
3.1.2Forces on a Flat Surface
3.1.3Forces on a Curved Surface
3.2Kinematics of the Blade
3.3Blade – Fluid Interaction
3.4CD and CL as Functions of Angle of Attack
CHAPTER FOUR:MATERIAL SELECTION AND SEQUENCE OF OPERATION
4.1Material Selection
4.2Sequence of Operation
CHAPTER FIVE:COST ANALYSIS
5.1Material Cost
5.2Direct Labour Cost
5.3Overhead Cost
CHAPTER SIX:PERFORMANCE EVALUATION, RECOMMENDATIONS AND CONCLUSIONS
6.1Performance Evaluation
6.2Recommendation
6.3Conclusions
References