ABSTRACT Proper management of thin oil rim reservoirs is required to maximize recovery and minimizes coning tendencies. The objective of this study is to determine the effect of reservoir and fluid properties on coning tendencies in thin oil rim reservoirs and to develop numerical correlations to predict oil recovery and water break through time for these reservoirs. Numerical correlations for the prediction of recovery and water breakthrough time using response surface methodology have bee...
ABSTRACT Coning tendencies in oil rim reservoirs pose serious hindrance to optimizing oil production in the thin oil beds as unwanted fluids tend to replace the oil in the production stream, which invariably limits the ultimate oil recovery. In this study, a semi-analytical method of estimating critical production rate (qoc) and optimum horizontal well placement (hopt) was developed for reservoirs with thin oil zones sandwiched between gas cap and bottom water. Also, proxy models was genera...
ABSTRACT This study presents a generalized analytical formulation of the Multi-Well Interference test problem using the concepts of the source and sinks functions as a tool for solving the basic interference equations.
ABSTRACT The effects of fiscal terms on true government take under joint petroleum ventures and production sharing contracts were investigated. A generalized cash flow model was developed and used to evaluate government revenues under different fiscal terms and contractual agreements. Analyses revealed that government take is reduced in joint ventures with divestment of equity if other fiscal terms remain unchanged.
INTRODUCTION Interfacial tension between two immiscible fluids arises from the dissimilarity of the intermolecular forces between the molecules in the phases. According to Shen et al [1] Interfacial tension affects two-phase flow and displacement processes in porous media. Interfacial films could also contain ionizable groups such as asphaltenes, resins, organic acids and solids which affect the physical properties of emulsions and the solubility of some polar organic compounds at the oil-wa...
ABSTRACT All over the world, there is an increasing enrolment level for university admissions in view of the ever-increasing benefits of eaming university degrees. Thus, the high population of students in many universities, coupled with a high number of vehicles has made traffic control a challenge to University traffic managers. In this paper, the method of Resca1e Range Analysis (RRA) was used to estimate the Hurst Exponent Value (HEV) for the traffic inflow through the main entrance gate o...
ABSTRACT Filtrate losses and filter cake properties of drilling fluids are of concern in the oil industry because they alter near well bore permeability and can reduce well productivity. Therefore, it is desirable to accurately characterize filtration process during oil well drilling. A mathematical model for analyzing mud filtration in deviated wells was developed in this study. The model determined solid pressure distribution within cake, cake thickness, cumulative volume of filtrate and e...
ABSTRACT Contamination of oilfield cement slurries by drilling fluids is one of the causes of cement job failures and it results in expensive remedial actions. While the general adverse effects of Pseudo Oil Base Mud (POBM) contamination of cement slurries are known, little has been published on the actual effects of POBM on specific slurry properties. The effect of POBM on the filtration losses in oil well cement slurries was investigated. POBM contaminated slurries at varying contamination ...
ABSTRACT Water production during petroleum production often contain chemical, oils and sometimes naturally occurring radioactive materials, which could harm the environment.
ABSTRACT Determining the filtration properties of a mud system requires that experiments be run for both the standard API and the high temperature pressure tests at intervals throughout the duration of drilling an oil well.
ABSTRACT Cubic equations of state are commonly used for predicting the properties of reservoir fluids.' They are simple to use and require few parameters during computations. They have also been found to produce results that are comparable to the more rigorous multi-parameter equations. However, they are still regarded by many as mere comprehensive correlations of fluid properties because of a number of weaknesses and /imitations. This work addresses two weaknesses of cubic equations of state...
ABSTRACT Direct viscosity measurements are often expensive or unavailable. Therefore, empirical correlations are often used for predicting the viscosity of crude oils. However, several published correlations are either too simplistic or too complex for routine operational use, Many of the common correlations in use were developed using data from other regions of the world, Empirical correlations for predicting the viscosity of light crude oils in the Niger Delta have been presented in this pa...
Abstract Surface tension is an important property that affects the behavior and characteristics of reservoir fluids.. It impacts the capillary pressure and fluid dynamics in porous media. This study, investigated the surface tension of Contaminated Niger Delta crude oil at varying temperatures. Laboratory tests were carried out on samples from four fields in the Niger Delta using DuNouy Tensiometer under standard conditions. The results show that for Niger Delta Crudes of gravity between 25 ...
ABSTRACT This study investigated the relationship between velocity of sound and properties of natural gases under different equations of state and the operational implications on acoustic gas metering. The velocity of sound was related to the thermodynamic properties of natural gas using both the Soave-Redlich-Kwong (SRK) and Peng-Robinson (PR) equations of state and applied to 5 wet and 5 dry natural gas samples from the Niger Delta at different conditions of temperature and pressure. Predic...
ABSTRACT Sand production, which is predominant in the Niger Delta, is a growing concern in the petroleum industry because of the associated technical, operational and economic challenges. The development of sanding predictive tools and effective management strategies has received much attention in literature. However, most of the published theoretical models have been validated with laboratory or data obtained from petroleum provinces other than the Niger Delta. This work developed a simple ...